Norfluran

Gefahreninformationscode (GHS)

• Bildanzeige (GHS)

  

• Alarmwort

  Warnung

• Gefahrenhinweise

  H280：Enthält Gas unter Druck; kann bei Erwärmung explodieren.

• Sicherheit

  P410+P403：Vor Sonnenbestrahlung schützen. An einem gut belüfteten Ort aufbewahren.

1,1,1,2-Tetrafluoroethane Chemische Eigenschaften,Einsatz,Produktion Methoden

• ERSCHEINUNGSBILD

  KOMPRIMIERTES FLüSSIGGAS MIT CHARAKTERISTISCHEM GERUCH.

• CHEMISCHE GEFAHREN

  Bei Kontakt mit heißen Gegenständen oder Flammen Zersetzung unter Bildung giftiger und ätzender Rauche.

• ARBEITSPLATZGRENZWERTE

  TLV nicht festgelegt (ACGIH 2005).
  MAK: 1000 ppm 4200 mg/m? Spitzenbegrenzung: überschreitungsfaktor II(8); Schwangerschaft: Gruppe C; (DFG 2005).
  

• AUFNAHMEWEGE

  Aufnahme in den Körper durch Inhalation.

• INHALATIONSGEFAHREN

  Eine gesundheitsschädliche Konzentration des Gases in der Luft wird beim Entweichen aus dem Behälter sehr schnell erreicht.

• WIRKUNGEN BEI KURZZEITEXPOSITION

  WIRKUNGEN BEI KURZZEITEXPOSITION:
  Schnelle Verdampfung kann zu Erfrierungen führen. Möglich sind Auswirkungen auf Zentralnervensystemund Herz-Kreislaufsystem mit nachfolgenden Herzfunktionsstörungen.

• LECKAGE

  Wasserstrahl NIEMALS auf die Flüssigkeit richten. NICHT in die Umwelt gelangen lassen. Chemikalienschutzanzug mit umgebungsluftunabhängigem Atemschutzgerät.

• S-Sätze Betriebsanweisung:

  S23:Gas/Rauch/Dampf/Aerosol nicht einatmen(geeignete Bezeichnung(en) vom Hersteller anzugeben).
  S38:Bei unzureichender Belüftung Atemschutzgerät anlegen.

• Chemische Eigenschaften

  Tetrafluoroethane is a liquefied gas and exists as a liquid at room temperature when contained under its own vapor pressure, or as a gas when exposed to room temperature and atmospheric pressure. The liquid is practically odorless and colorless. The gas in high concentrations has a slight etherlike odor. Tetrafluoroethane is noncorrosive, nonirritating, and nonflammable.

• Chemische Eigenschaften

  colourless gas or cryogenic liquid with an ether-like odour

• Verwenden

  Refrigerant, propellant for pharmaceuticals; blowing agent for foams.

• Vorbereitung Methode

  Tetrafluoroethane can be prepared by several different routes; however, the following routes of preparation illustrate the methods used:
  Isomerization/hydrofluorination of 1,1,2-trichloro-1,2,2-trifluoroethane (CFC-113) to 1,1-dichloro-1,2,2,2-tetrafluoroethane (CFC-114a), followed by hydrodechlorination of the latter. Hydrofluorination of trichloroethylene, via 1-chloro-1,1,1- trifluoroethane (HCFC-133a).

• Allgemeine Beschreibung

  A colorless gas with a slight ethereal odor. Vapors are heavier than air. Shipped liquefied under own vapor pressure. Flash point 351°F. Inhalation at high concentrations is harmful and may cause heart irregularities, unconsciousness or death without warning. Liquid contact may cause frostbite. Vapors can replace the available oxygen.

• Air & Water Reaktionen

  Insoluble in water.

• Reaktivität anzeigen

  1,1,1,2-Tetrafluoroethane is chemically inert in many situations, but can react violently with strong reducing agents such as the very active metals and the active metals. Can react with strong oxidizing agents or weaker oxidizing agents under extremes of temperature.

• Health Hazard

  Vapors may cause dizziness or asphyxiation without warning. Vapors from liquefied gas are initially heavier than air and spread along ground. Contact with gas or liquefied gas may cause burns, severe injury and/or frostbite. Fire may produce irritating, corrosive and/or toxic gases.

• Brandgefahr

  Some may burn but none ignite readily. Containers may explode when heated. Ruptured cylinders may rocket.

• Flammability and Explosibility

  Non flammable

• Pharmazeutische Anwendungen

  Tetrafluoroethane is a hydrofluorocarbon (HFC) or hydrofluoroalkane (HFA) aerosol propellant (contains hydrogen, fluorine, and carbon) as contrasted to a CFC (chlorine, fluorine, and carbon). The lack of chlorine in the molecule and the presence of hydrogen reduce the ozone depletion activity to practically zero. Hence tetrafluoroethane is an alternative to CFCs in the formulation of metereddose inhalers (MDIs). It has replaced CFC-12 as a refrigerant and propellant since it has essentially the same vapor pressure. Its very low Kauri-butanol value and solubility parameter indicate that it is not a good solvent for the commonly used surfactants for MDIs. Sorbitan trioleate, sorbitan sesquioleate, oleic acid, and soya lecithin show limited solubility in tetrafluoroethane and the amount of surfactant that actually dissolves may not be sufficient to keep a drug readily dispersed. Up to 10% ethanol may be used to increase its solubility.
  When tetrafluoroethane (P-134a) is used for pharmaceutical aerosols and MDIs, the pharmaceutical grade must be specified. Industrial grades may not be satisfactory due to their impurity profiles.

• Sicherheit(Safety)

  Tetrafluoroethane is used as a refrigerant and as a non-CFC propellant in various aerosols including topical pharmaceuticals and MDIs. Tetrafluoroethane is regarded as nontoxic and nonirritating when used as directed. No acute or chronic hazard is present when exposures to the vapor are below the acceptable exposure limit (AEL) of 1000 ppm, 8-hour and 12-hour time weighed average (TWA). In this regard it has the same value as the threshold limit value (TLV) for CFC-12. Inhaling a high concentration of tetrafluoroethane vapors can be harmful and is similar to inhaling vapors of CFC-12. Intentional inhalation of vapors of tetrafluoroethane can be dangerous and may cause death. The same labeling required on CFC aerosols would be required for those containing tetrafluoroethane as a propellant (except for the EPA requirement).

• Carcinogenicity

  The results from three lifetime inhalation carcinogenesis studies with HFC 134a have been published. The first one involved exposure of groups of 80 male and 80 female rats to levels of ≤50,000 ppm 6 h/ day, 5 days/week for 2 years.An increase inLeydig cell tumors was seen in themale rats at 50,000 ppm(30%) compared to the air-exposed controls (12%). Likewise, therewas an increase in Leydig cell hyperplasia. No effects were seen at 10,000 ppm (370). The second study with rats involved snout-only inhalation exposures to levels of ≤50,000 ppm 1 h/day, 7 days/week for 108 weeks. The same investigators conducted a lifetime study withmice. In this study, groups of mice were exposed to snout-only levels of ≤75,000 ppm 1 h/day, 7 days/week for 104 weeks. No adverse effects were seen in either rats or mice. Since the total dose received by the rats in the high exposure level of this study was lower than in the Collins’ study, this report supports the observation that 10,000 ppm, 6 h/day, 5 days/week for 2 years was a NOEL.
  Rats were given 300 mg of HFC 134a in corn oil 5 days/ week for 52 weeks and held for a total of 125 weeks. There was no evidence for carcinogenicity.

• Lager

  Tetrafluoroethane is a nonreactive and stable material. The liquified gas is stable when used as a propellant and should be stored in a metal cylinder in a cool dry place.

• Inkompatibilitäten

  The major incompatibility of tetrafluoroethane is its lack of miscibility with water. Since it has a very low Kauri-butanol value, tetrafluoroethane is considered to be a very poor solvent for most drugs used in MDI formulations. It also shows a low solubility for some of the commonly used MDI surfactants.

• Regulatory Status

  Included in the FDA Inactive Ingredients Database (aerosol formulations for inhalation and nasal applications). Included in nonparenteral medicines licensed in the UK.

1,1,1,2-Tetrafluoroethane Upstream-Materialien And Downstream Produkte

Norfluran Anbieter Lieferant Produzent Hersteller Vertrieb Händler.

Global(1)Suppliers

811-97-2, 1,1,1,2-Tetrafluoroethane Verwandte Suche: