Ceftazidim

Gefahreninformationscode (GHS)

• Bildanzeige (GHS)

  

• Alarmwort

  Achtung

• Gefahrenhinweise

  H317：Kann allergische Hautreaktionen verursachen.

  H334：Kann bei Einatmen Allergie, asthmaartige Symptome oder Atembeschwerden verursachen.

• Sicherheit

  P261：Einatmen von Staub vermeiden.

  P272：Kontaminierte Arbeitskleidung nicht außerhalb des Arbeitsplatzes tragen.

  P280：Schutzhandschuhe/Schutzkleidung/Augenschutz tragen.

  P284：Atemschutz tragen.

  P501：Inhalt/Behälter ... (Entsorgungsvorschriften vom Hersteller anzugeben) zuführen.

CeftazidiMe Chemische Eigenschaften,Einsatz,Produktion Methoden

• R-Sätze Betriebsanweisung:

  R20/21/22:Gesundheitsschädlich beim Einatmen,Verschlucken und Berührung mit der Haut.
  R36/37/38:Reizt die Augen, die Atmungsorgane und die Haut.

• S-Sätze Betriebsanweisung:

  S26:Bei Berührung mit den Augen sofort gründlich mit Wasser abspülen und Arzt konsultieren.
  S36:DE: Bei der Arbeit geeignete Schutzkleidung tragen.

• Beschreibung

  In ceftazidime the oxime moiety is more complex, containing two methyl groups and a carboxylic acid. This assemblage conveys even more pronounced β-lactamase stability, greater anti–Pseudomonas aerugi nosa, and increased activity against Gram-positive organisms. The C-3 side chain has been replaced by a charged pyridinium moiety. The latter considerably enhances water solubility and also highly activates the β-lactam bond toward cleavage. The drug must be protected against heat and light and may darken without significant loss of potency. It is not stable under some conditions. such as the presence of aminoglycosides and vancomycin. It also is attacked readily in sodium bicarbonate solutions. Resistance is mediated by chromosomally mediated β-lactamases and by lack of penetration into target bacteria. Otherwise, it has a very broad antibacterial spectrum.

• Chemische Eigenschaften

  solid

• Originator

  Fortum,Glaxo,UK,1983

• Verwenden

  pyrimidine synthesis inhibitor disease-modifying antirheumatic drug

• Verwenden

  5-HT agonist, anti-migrane

• Verwenden

  Third generation cephalosporin antibiotic. Antibacterial

• Verwenden

  Like most of the third-generation cephalosporin antibiotics described above, ceftazidime has a broad spectrum of antimicrobial action, including the most clinically important microorganisms: Gram-positive, Gram-negative, aerobic, and anaerobic. It is resistant to most beta-lactamases of Gram-positive and Gram-negative bacteria. It is used for treating most serious bacterial infections. Synonyms of this drug are fortum, ceftim, stacef, and tazicef.

• Definition

  ChEBI: A cephalosporin bearing pyridinium-1-ylmethyl and {[(2Z)-2-(2-amino-1,3-thiazol-4-yl)-2-{[(2-carboxypropan-2-yl)oxy]imino}acetamido groups at positions 3 and 7, respectively, of the cephem skeleton.

• Manufacturing Process

  (a) t-Butyl(6R,7R)-3-acetoxymethyl-7-[(Z)-2-(2-t-butoxycarbonylprop-2- oxyimino)-2-(2-tritylaminothiazol-4-yl)acetamido]ceph-3-em-4-carboxylate: A stirred solution of (Z)-2-(2-t-butoxycarbonylprop-2-oxyimino)-2-(2- tritylaminothiazol-4-yl)acetic acid (572 mg) and t-butyl(6R,7R)-3- acetoxymethyl-7-aminoceph-3-em-4-carboxylate (328 mg) in dimethylformamide (10 ml) was cooled to 0°C, and 1-hydroxybenzotriazole (150 mg) was added, followed by dicyclohexylcarbodiimide (225 mg). The mixture was warmed to room temperature, stirred for 5 hours and allowed to stand overnight. The mixture was filtered, and the white solid washed with a little ether. The filtrate and washings were diluted with water (50 ml) and extracted with ethyl acetate. The organic extracts were combined, washed successively with water, 2 N hydrochloric acid, water, sodium bicarbonate solution, and saturated brine, dried and evaporated. The residue was eluted through a silica column with ether. The product-containing eluate was collected and concentrated to give the title compound (533 mg). A portion was recrystallized from diisopropyl ether, MP 103°C to 113°C (decomp.); [α]D20 +8.5 (conc. 1.0, DMSO).
  (b) (6R,7R)-3-Acetoxymethyl-7-[(Z)-2-(2-aminothiazol-4-yl)-2-(2- carboxyprop-2-oxyimino)acetamido]ceph-3-em-4-carboxylic acid: Trifluoroacetic acid (18 ml) was added to a solution of the product of (a) (2.4 g) in anisole (18 ml) at 0°C. The mixture was stirred at room temperature for 2 hours and concentrated. The residue was dissolved in ethyl acetate and extracted with saturated sodium bicarbonate solution. The pH of the aqueous extracts was adjusted to 6, and the solution washed with ethyl acetate. The aqueous phase was acidified to pH 1.5 under ethyl acetate, saturated with sodium chloride, and extracted with ethyl acetate. The combined organic extracts were washed with saturated brine, dried and evaporated. The residue was dissolved in warm 50% aqueous formic acid (20 ml) and allowed to stand for 2 hours. The mixture was diluted with water (50 ml) and filtered. The filtrate was concentrated. The residue was taken up in water (50 ml), refiltered, and lyophilized to give the title compound (920 mg).
  (c) (6R,7R)-7-[(Z)-(2-Aminothiazol-4-yl)-2-(2-carboxyprop-2- oxyimino)acetamido]-3-(1-pyridiniummethyl)-ceph-3-em-4-carboxylate, monosodium salt: Pyridine (2 ml) and the product of (b) (1.8 g) were added to a stirred solution of sodium iodide (7.12 g) in water (2.2 ml) at 80°C. The solution was stirred at 80 C for 1 hour, cooled, and diluted to 100 ml with water. The pH of the solution was adjusted to 6.0 with 2N sodium hydroxide solution, and this solution was concentrated to remove pyridine. The aqueous residue was diluted to 100 ml with water, methyl isobutyl ketone (2 drops) was added, and the solution was acidified to pH 1 with 2 N hydrochloric acid. The mixture was filtered, and the solid was washed with a little water. The filtrate and washings were collected and washed with ethyl acetate, and the pH adjusted to 6.0 with 2 N sodium hydroxide solution. The solution was concentrated to 50 ml and applied to a column of 500 g Amberlite XAD-2 resin, using first water and then 20% aqueous ethanol as eluting solvent. The product-containing fractions were concentrated and lyophilized to give the title compound (0.56 g).

• Trademarks

  Fortaz (GlaxoSmithKline); Tazicef (Hospira); Tazidime (Lilly).

• Therapeutic Function

  Antibiotic

• Clinical Use

  Antibacterial agent

• Synthese

  Ceftazidime is 1-[[7-[[(2-amino-4-thiazolyl)[(1-carboxy-1-methylethoxy) imino]acetyl]amino]-2-carboxy-8-oxo-5-thia-1-azabicyclo[4.2.0]oct-2-en-3- yl]methyl]pyridin-2-carboxylic acid (32.1.2.82). As is the case in synthesis of ceftriazone, the synthesis of ceftazidime requires the preliminary synthesis of two starting compounds. 7-Amino-3-(1-pyridinomethyl)cef-3-en-carboxylic acid dihydrochloride is used as the cephalosporin fragment, while the acyl fragment is a modified structure of (32.1.2.77), which is not a derivative of 2-(2-amino-4-thiazolyl)-2-methoxyminoacetic acid, but a derivative of 2-(2-amino-4-thiazolyl)-2-(2-tert-butoxycarboxyl-2-propyloximino)acetic acid, which is synthesized by the following scheme. Nitration of acetoacetic ester gives isonitrosoacetoacetic ester (32.1.2.49), which undergoes chlorination by sulfuryl chloride in methylene chloride to form 4-chloro-2-hydroximinoacetoacetic ester (32.1.2.73).
  Reacting this with thiourea in the classic scheme of thiazole synthesis by reacting of |á-halogencarbonyl compounds with thioamides forms the ethyl ester of (Z)-2-(2-aminothiazole-4-yl)-2-hydroxyminoacetic acid (32.1.2.74). The amino group in this molecule is protected by a reaction with triphenylchloromethane in dimethylformamide in the presence of triethylamine, which gives the ethyl ester of (Z)-2-(2-tritylaminothiazole-4-yl)- 2-hydroxyminoacetic acid (32.2.3.75). The hydroxyl group in the resulting compound is alkylated with the tert-butyl ester of |á-bromoisobutyric acid in dimethylsulfoxide in the presence of potassium carbonate, giving ethyl ester of 4-thiazoleacetic acid, |á -[[2-(1,1-dimethylethoxy)-1,1-dimethyl-2-oxoethoxy]imino]-2- [(triphenylmethyl)amino], (Z) (32.1.2.76). The ethoxycarbonyl group in this molecule is hydrolyzed by sodium hydroxide, and upon working up the reaction mixture with an acid, the corresponding acid (32.1.2.77) is isolated (32.1.2.77). Upon interaction with phosphorous pentachloride the acid chloride (32.1.2.78) is obtained, which is used further as the acylating reagent.
  The second necessary fragment, 7-amino-3-(1-pyridinomethyl)cef-3-en-carbonic acid (32.1.2.80), is synthesized from cefalosporidin (32.1.2.79), a cephalosporin antibiotic that is used independently in medicine and which is synthesized in the form of an internal salt by reacting cefalotin (32.1.2.1) with pyridine to replace the acetoxyl group with a pyridine group. Initially treating cephaloridin with trimethylchlorosilane in the presence of dimethylaniline and then with phosphorous pentachloride, followed by a reaction with 1, 3-butandiol results in the creation of 7-amino-3-(1-pyridinomethyl)cef-3-en-carboxylic acid (32.1.2.80). This is acylated by the acid chloride (32.1.2.78) synthesized earlier, forming the product (32.1.2.81), which is treated with a mixture of formic and hydrochloric acids to remove both protective groups (triphenylmethyl and tert-butyl), giving ceftazidime (32.1.2.82) in the form of a dihydrochloride.

  

• Arzneimittelwechselwirkung

  Potentially hazardous interactions with other drugs
  Anticoagulants: effects of coumarins may be enhanced.
  Ciclosporin: may cause increased ciclosporin levels.

• Stoffwechsel

  Ceftazidime is passively excreted in bile, although only a small proportion (1%) is eliminated by this route. It is mainly excreted by the kidneys, almost exclusively by glomerular filtration; probenecid has little effect on the excretion. About 80-90% of a dose appears unchanged in the urine within 24 hours.

CeftazidiMe Upstream-Materialien And Downstream Produkte

Ceftazidim Anbieter Lieferant Produzent Hersteller Vertrieb Händler.

Global(414)Suppliers

72558-82-8, CeftazidiMe Verwandte Suche: