Supplier Product Identification Physical and Chemical Properties First Aid Measures Handling and Storage Hazards Identification Exposure Controls/Personal Protection Fire Fighting Measures Accidental Release Measures Stability and Reactivity
Home > Chlorinated waxes > Chlorinated waxes(63449-39-8)

Chlorinated waxes(63449-39-8)

Supplier Product Identification Physical and Chemical Properties First Aid Measures Handling and Storage Hazards Identification Exposure Controls/Personal Protection Fire Fighting Measures Accidental Release Measures Stability and Reactivity

Product Identification

Product Name
Chlorinated waxes
Synonyms
Cereclor
Chlorcosane
Chlorinated paraffins (C23, 43% chlorine)
Chlorowax 40
Paraffin waxes and Hydrocarbon waxes, chloro
CAS
63449-39-8
EINECS
264-150-0
RTECS
RV0450000
RTECS Class
Primary Irritant
Beilstein/Gmelin
NA

Physical and Chemical Properties

Appearance
Clear, colorless liquid.
Density
1.12 g/cm3 (20 C)
Usage
As solvent for dichloramine-t, dissolving about 8%.

First Aid Measures

Ingestion
Emesis is not indicated due to the irritant nature of these agents. Charcoal - not recommended; it may promote vomiting and make endoscopic evaluation difficult. Dilution: immediately dilute with 4 to 8 ounces (120 to 240 ml) of milk or water (not to exceed 4 ounces/120 ml in a child). Neutralization - neutralization is not indicated. Although these agents are irritants, and therefore should not produce tissue damage, it is almost impossible to assure that a particular substance under a particular set of circumstances would not cause damage. Therefore, each patient should be examined with the idea that mucous membrane damage might have occurred.
Inhalation
Move patient to fresh air. Monitor for respiratory distress. If cough or difficulty breathing develops, evaluate for respiratory tract irritation, bronchitis, or pneumonitis. Administer oxygen and assist ventilation as required. Treat bronchospasm with beta2 agonist and corticosteroid aerosols.
Skin
Remove contaminated clothing. Wash exposed area with soap and water. If symptoms persist, seek medical attention. Launder clothing before reuse.
Eyes
Irrigate exposed eyes with copious amounts of tepid water for at least 15 minutes. If irritation, pain, swelling, lacrimation, or photophobia persist, the patient should be seen in a health care facility. If in a medical facility, sterile saline should be used to irrigate the eyes until the cul de sac is returned to neutrality. Some alkali exposures may require prolonged irrigation.

Handling and Storage

Storage
Keep tightly closed in a cool place in a tightly closed container.
Handling
Containers of this material may be hazardous when emptied. Since emptied containers retain product residues (vapor, liquid, and/or solid), all hazard precautions given in the data sheet must be observed.

Hazards Identification

Inhalation
Cough, tachypnea, and wheezing are common after inhalation.
Skin
Redness, swelling and pain may occur.
Eyes
May cause mild eye irritation. Symptoms include stinging, tearing, and redness.
Ingestion
Nausea, vomiting and diarrhea are possible if ingested.

Exposure Controls/Personal Protection

Personal Protection
Chemical splash goggles in compliance with OSHA regulations are advised; however, OSHA regulations also permit other type safety glasses. Whre chemical resistant gloves. To prevent repeated or prolonged skin contact, wear impervious clothing and boots.
Respirators
If overexposure has been determined or documented, a NIOSH/MSHA jointly approved air supplied respirator is advised in absence of proper environmental control. OSHA regulations also permit other NIOSH/MSHA respirators under specified conditions.
Exposure Effects
Symptoms of exposure to this material through breathing, swallowing, and/or passage of the material through the skin may include: stomach or intestinal upset (nausea, vomiting, diarrhea) irritation (nose, throat, airways), central nervous system depression (dizziness, drowsiness, weakness, fatigue, nausea, headache, unconsciousness), and death.
Poison Class
-

Fire Fighting Measures

Flash Point
204
Fire Fighting
Extinguish fire using most appropriate media for surrounding fire. Wear a self-contained breathing apparatus with a full facepiece operated in the positive pressure demand mode with appropriate turn-out gear and chemical resistant personal protective equipment.

Accidental Release Measures

Small spills/leaks
Small Spill - Absorb liquid on vermiculite, floor absorbent, or other absorbent material and transfer to hood. Large Spill - Persons not wearing protective equipment should be excluded from area of spill until clean-up has been completed. Stop spill at source, dike area of spill to prevent spreading, pump liquid to salvage tank. Remaining liquid may be taken up on sand, clay, earth, floor absorbent, or other absorbent material and shoveled into containers.

Stability and Reactivity

Incompatibilities
Alkali metals, excessive heat, powdered metals.
Stability
Stable.
Decomposition
Hydrogen chloride, various hydrocarbons.
Contact More