Aceclidin

Aceclidine Chemische Eigenschaften,Einsatz,Produktion Methoden

• Originator

  Glacostat ,MSD-Chibret ,France ,1966

• Verwenden

  analgesic (topical), depletes Substance P, neurotoxic

• Definition

  ChEBI: Acetic acid 1-azabicyclo[2.2.2]octan-3-yl ester is a member of quinuclidines.

• Manufacturing Process

  A mixture of 274 g of methyl isonicotinate, 367 g of ethyl bromoacetate and 125 cc of ethyl alcohol was stirred without heating for 4 hours in a flask equipped with a reflux condenser. (The reaction was exothermic and precautions were taken to keep the temperature below 70°C.) The reaction mixture was then left for 15 hours at room temperature.
  The reaction product (1-carbethoxymethyl-4-carbornethoxy-pyridinium bromide) was obtained in crystalline form. (It formed prisms melting at 166- 169°C after recrystallization from a mixture of isopropanol and acetone.) It was not necessary to isolate it. For the following reduction step, the reaction mixture was brought into solution by the addition of about 1 liter of warm ethyl alcohol. It was then hydrogenated at about 30 atm pressure in the presence of 2 g of platinum oxide. The temperature rose during this reaction to about 40°C. After the calculated amount of hydrogen had been absorbed, the catalyst was filtered off, the solution was concentrated in vacuum, and the residual syrup was dissolved in ice water. Benzene was added and the mixture was made alkaline with an excess of concentrated ice cold potassium carbonate solution. The temperature was kept low by continuous addition of ice, and the benzene layer was separated and dried with sodium sulfate. The dried benzene solution was concentrated in vacuum and the residual oil was distilled in vacuum. BP 30 mm = 175-182°C, nD 25= 1.4613-1.4628. During the reduction, partial alcoholysis occurred, and the product isolated was 1- carbethoxymethyl-4-"carbalkoxy"-piperidine, wherein "carbalkoxy" represents a mixture of carbomethoxy and carbethoxy.
  100 g of potassium were pulverized in 200 cc of hot toluene in a heated three-neck flask equipped with an efficient condenser, stirrer and dropping funnel. To the refluxing potassium suspension were added in small portions 229 g of the product of the previous step and about 700 cc of toluene. This addition had to be carried out very cautiously; the onset of the exothermic reaction is sometimes delayed. The addition was finished in about 1 hour. To complete the reaction, the refluxing and stirring were continued for about 4 hours. The reaction mixture was then cooled to about +5°C and about 50 cc isopropanol were added to decompose unreacted potassium. Then 2.5 liters of concentrated hydrochloric acid were added and the mixture was refluxed for 15 hours, and then concentrated in vacuum to dryness. To the residue was added with cooling an excess of 50% potassium hydroxide. Ether was then added and the resulting mixture was filtered through a fritted glass funnel, thus removing the precipitated potassium chloride. The ethereal and aqueous layers were separated, and the aqueous layer was extracted repeatedly with 500 cc portions of ether. The organic solutions were combined, dried over sodium sulfate and concentrated in vacuum. Aqueous hydrochloric acid was added to the residue until the solution became acid. The mixture was then diluted with distilled water to about 300 cc, heated with decolorizing charcoal, filtered and concentrated in vacuum to dryness. The residue was treated with isopropanol, and the precipitated crystalline product was filtered off. The product was recrystallized from a mixture of water and isopropanol and was identified as 1-azabicyclo[2.2.2]-3-octanone hydrochloride; prisms, MP 311- 313°C, with decomposition.
  A solution of 50 g of the above ketone-hydrochloride in 30 cc of water was made alkaline by the addition of 30 g of potassium hydroxide. After the alkali was dissolved, 35 g of granular potassium carbonate were added. The free basic ketone was then extracted from the viscous mixture by shaking with 4 portions of hot benzene (300 cc in each portion). The benzene extracts were decanted, filtered over sodium sulfate in order to remove any suspended alkali, and concentrated in vacuum. The residual lszabicyclo[2.2.2]-3-octanone was purified by sublimation (50

• Trademarks

  Cholinergic Glaucostat (Kingshill Pharmaceuticals, Inc, Switzerland).

• Therapeutic Function

  Miotic, Cholinomimetic

• Sicherheitsprofil

  Poison by ingestion, subcutaneous,and intravenous routes. When heated to decomposition itemits toxic fumes of NOx.

Aceclidine Upstream-Materialien And Downstream Produkte

Aceclidin Anbieter Lieferant Produzent Hersteller Vertrieb Händler.

Global(68)Suppliers

827-61-2, Aceclidine Verwandte Suche: