水性脱模剂

主要用于PU鞋底脱模，以水为分散介质，不含任何有毒有害物质。本产品分散性好，易于喷涂，使用方便，脱模力小;耐气候性好，储存性能稳定;对模具表面无腐蚀，结垢少，便于清洗。 将脱模剂用去离子水稀释到适当浓度，由于鞋底在脱模时的熟化程度和密度不一样，稀释脱模剂时应按鞋底的工艺要求分别稀释。稀释比例应根据本厂的具体工艺而定，建议倍数15～30。 1、喷涂脱模剂前，模具一定要用溶剂清理干净，务必使模具表面无铁锈或其它污染物，然后再涂脱模剂使用。 2、次喷涂脱模剂时，务必适当增大喷涂量。 3、喷涂的脱模剂必须均匀分布在整个模具表面，不能留有死角，在模具的棱角部位要适当增大喷涂量。 4、喷完脱模剂后，用气体将模具吹干后再注料。 5、必须保证盛脱模剂的容器和压缩空气干燥。 6、没用完的脱模剂不能再倒回原包装桶内，以防止脱模剂污染变质。 Description: Skin shine,low cost,secure than oil base release. Water based release agent is professional for PU soles, with intensely bright,strong skin,without foaming line,easy clear the mould.needn't wash the sole bfore spray colour. DESCRIPTION Water based release agent for PU shoe sole. CHARACTERISTICS Water based emulsion APPLICATION Clean well the mould. Mix with water before using,dilute rate1KG release agent mix with 8~12KG normal water. Mould temperature: 50-70degree. Spray using nozzle gun diam 0.3 mm. Tank pressure 0,8 -1 bar. Air pressure 2,5 bar. Spray the release agent directly into the mould. After spraying the release agent dry it with air,and clean by cotton. ADVANTAGES No solvent content Environmental friendly product PACKING Plastic cans of 25KG. STORAGE Keep in well closed original packing in a dry and ventilated place. Shelf life, 12 months. Avoid extreme cold-heat (preferably +5/30 degree) IF YOU CANNOT PLAY THE VEDIO,PLEASE LINK FROM YOUTUBE:http://youtu.be/_Tpjbj4ZaYw