PVC lubricant
Normally, there two types of lublicant for PVC indutry, internal and external lubricant.
An internal lubricant is with good performance at:
1.Reducing heat in production process;
2.Give lower melt viscosity;
3.Postpone gelation;
4.Improve flow charateristics.
While an external lubricant supporting following performance:
1.Delay gelation;
2.Improve gloss;
3.Reduce friction;
4.Provide release properties.
For PVC process, Internal lubricants mainly including:
Stearic acid, Calcium stearate, GMS, DMG, n-butyl stearate,
As for external lubricants for PVC, these are popularly used:
PE wax,Paraffin wax.
Oxidized Polyethylene A-T 316A is a typical external lubricant. As a substitute of Honeywell A-C 316A, it can significantly support plasticization and improve melt strength, and with good de-moulding performance.
POSTED BY ADDTEDK CHEMICAL.
ADDTEDK PRODUCTS:
• Methoxy Propanol Acetate(PMA) • Methoxy Propanol(PM) • Mixture PMA+EEP
• Isopropyl alcohol(IPA) • Di Isobutyl Ketone • o-cresol • Lithium hydroxide
• Phosphorus-Pentachloride • Phosphorus trichloride • Phosphorus oxychloride
• Tranexamic acid • 2-octyl-1-dodecanol • 4-Butylresorcinol
• 2-ETHYL HEXYL DI GLYCOL • Surfynol • Chloroprene Rubber
• LINEAR ALKYLBENZENE (LAB) • Potassium Laurate • Palmamide methyl MEA
• SLES 70% • LABSA • Cocamide methyl MEA • Cocamidopropylamine Oxide
• Palmitoyl Chloride • 2-Ethylhexanoyl chloride • Stearoyl Chloride
• Cocamidopropyl Betaine • Coconut Diethanolamide • Aloe Vera Gel
• DMAPA • Isoparaffins
