Supplier Product Identification Physical and Chemical Properties First Aid Measures Handling and Storage Hazards Identification Exposure Controls/Personal Protection Fire Fighting Measures Accidental Release Measures Stability and Reactivity Transport Information
Home > 2-Trifluoromethyl-4-fluorobenzaldehyde > 2-Trifluoromethyl-4-fluorobenzaldehyde(90176-80-0)

2-Trifluoromethyl-4-fluorobenzaldehyde(90176-80-0)

Supplier Product Identification Physical and Chemical Properties First Aid Measures Handling and Storage Hazards Identification Exposure Controls/Personal Protection Fire Fighting Measures Accidental Release Measures Stability and Reactivity Transport Information

Product Identification

Product Name
2-Trifluoromethyl-4-fluorobenzaldehyde
Synonyms
2-(Trifluoromethyl)-4-fluorobenzaldehyde
Benzaldehyde, 4-fluoro-2-(trifluoromethyl)-
CAS
90176-80-0
Formula
C8H4F4O
Molecular Weight
192.11
Beilstein/Gmelin
5932091

Physical and Chemical Properties

Appearance
Liquid.
Solubility in water
Insoluble
Boiling Point
114
Density
1.4 g/cm3
Vapor Density
6.62
Refractive Index
1.45 (20 C)

First Aid Measures

Ingestion
Never give anything by mouth to an unconscious person. Get medical aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation
Remove from exposure to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical aid.
Skin
Get medical aid. Flush skin with plenty of soap and water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse.
Eyes
Immediately flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical aid.

Handling and Storage

Storage
Store in a tightly closed container. Store in a cool, dry, well-ventilated area away from incompatible substances.
Handling
Wash thoroughly after handling. Avoid contact with eyes, skin, and clothing. Keep container tightly closed. Avoid ingestion and inhalation. Use with adequate ventilation. Wash clothing before reuse.

Hazards Identification

Ingestion
May cause gastrointestinal irritation with nausea, vomiting and diarrhea.
Inhalation
Causes respiratory tract irritation.
Skin
Causes skin irritation.
Eyes
Causes eye irritation.
Hazards
Vapors may form explosive mixtures with air. Vapors may travel to source of ignition and flash back. Most vapors are heavier than air. They will spread along ground and collect in low or confined areas (sewers, basements, tanks). Vapor explosion hazard indoors, outdoors or in sewers.
EC Risk Phrase
R 36/37/38
EC Safety Phrase
S 26 36
UN (DOT)
1993

Exposure Controls/Personal Protection

Personal Protection
Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166. Skin: Wear appropriate protective gloves to prevent skin exposure. Clothing: Wear appropriate protective clothing to prevent skin exposure.
Respirators
A respiratory protection program that meets OSHA's 29 CFR 1910.134 and ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace conditions warrant a respirator's use.

Fire Fighting Measures

Flash Point
56
Fire Fighting
Wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion. To extinguish fire use water spray, dry chemical, carbon dioxide, or appropriate foam.
Fire Potential
HIGHLY FLAMMABLE: Will be easily ignited by heat, sparks or flames.

Accidental Release Measures

Small spills/leaks
Clean up spills immediately, using the appropriate protective equipment. Sweep up or absorb material, then place into a suitable clean, dry, closed container for disposal. Provide ventilation.

Stability and Reactivity

Stability
Stable at room temperature in closed containers under normal storage and handling conditions.
Incompatibilities
Strong oxidizing agents.
Decomposition
Carbon monoxide, carbon dioxide, hydrogen fluoride.
Combustion Products
Fire may produce irritating, corrosive and/or toxic gases.

Transport Information

UN Number
1993
Hazard Class
3
Packing Group
I; II; III
Contact More