Dichlorooctylisothiazolinone, DCOIT or DCOI, is an isothiazolinone compound. It is a white solid that melts at room temperature. It is an organic chemical that is slightly volatile and can dissolve in water. The measured K values show that DCOIT tends to move from water to octanol and has moderate to high lipophilicity.
Dichloroctylisothiazolinone is used as a broad spectrum biocide. It is used in paints especially marine coatings, decorative wood coatings and plastic industry. It is used primarily as a dry-film mildew protector for paint, coatings, paper, stains, plastics, wood, shoes, adhesives, metalworking fluids and printing inks. It is easily incorporated into water-based or solvent-based formulations.
ChEBI: 4,5-dichloro-2-n-octyl-3(2H)-isothiazolone(DCOIT) is a 1,2-thiazole that is 1,2-thiazol-3(2H)-one substituted by chloro groups at positions 4 and 5 and an octyl group at position 2. It is used as a fungicide. It has a role as an environmental contaminant, a xenobiotic and a fungicide. It is an organochlorine compound and a member of 1,2-thiazoles.
Suitable for applications in the paints and coatings, wood, and leather fields to resist corrosion and protect against mildews and algae.
The chemical is referred to as 4,5-dichloro-2-n-octyl-4-isothiazolin-3-one (DCOIT) in this assessment. Where available, data for
two commercial antifouling products C-9211 HQ (32.6 % of DCOIT in xylene) and Acticide DCOIT (97.1% purity) are used for
some health end-points.
The information on health hazards is primarily obtained from the comprehensive reviews from the Norwegian Environment
Agency as part of its ECHA CLH proposal (ECHA, 2018) and an EU (Norway) DCOIT evaluation for the use of DCOIT as a
biocide in antifouling products (EU, 2014). Unless otherwise noted, references to individual studies below are taken from these
reviews.
Irritant and sensitizer, Kathon 930 caused contact
dermatitis in employees of a textile fnishing
factory.
The chemical, DCOIT is moderately absorbed through skin and moderately absorbed via oral route. It is then extensively
distributed to tissues (liver, kidney, stomach and intestine) and metabolised following oral administration.
In a study conducted in rats, 81–93 % of orally administered 14C-DCOIT was excreted primarily in the faeces within a 2-day
period. Plasma elimination half-life of 14C-DCOIT was 16.1–19.4 hours for males and 20.5–25.0 hours for females. The highest
concentration of 14C-DCOIT was found in liver, stomach, intestine and kidney. More than 80 % of the administered dose was
eliminated via faeces, 11–18 % was eliminated via urine and less than 2 % of the dose was eliminated through exhaled air.
DCOIT metabolised to form six metabolites in the faeces and eight metabolites in the urine. Degradation of DCOIT involves
cleavage of the ring and subsequent oxidation of 7–18 % of the administrated dose to N-(n-octyl) malonamic acid (NNOMA,
major metabolite), N-(n-octyl)acetamide, N-(n-octyl)oxamic acid and N-(n-octyl)-β-acetyl propionamide. The chemical undergoes
subsequent biotransformation involving hydroxylation, dealkylation and acetylation (EU, 2014; ECHA, 2018).
The chemical and formulations containing the chemical applied to intact rabbit skin produced severe erythema, oedema and scar formation. The exposed areas had effects that were not reversible. Data indicates corrosive effects in the respiratory tract. While no data are available for effects in the eyes, the chemical is deemed to capable of causing severe damage. There is sufficient evidence to warrant hazard classification.
Add 200 g of ethyl acetate and 23.6 g (0.1 mol) of N,N'-dimethyl-3,3'-dithiodipropionamide into a 500ml four-neck flask equipped with a thermometer and a stirrer, stir and mix, and control The reaction temperature was 15° C., 1.8 g of thionyl chloride (15.1 mmol) was added to the four-neck flask, and the mixture was stirred for 10 min.21.3g (0.3mol) of chlorine gas was introduced into the reaction system, the mixture was stirred for 5h to react, and 27.1g of 4,5-Dichloro-2-octyl-isothiazolone was obtained by filtration and separation. The yield was 84.9%.
In a bacterial gene mutation test, DCOIT was tested in Salmonella typhimurium strains TA98, TA100, TA1535 and TA1537 up to
a maximum concentration of 300 μg/plate with negative responses in all strains with and without metabolic activation (EU,
2014; ECHA, 2018).
In two micronucleus assays, DCOIT was tested in CD-1 mice (5-9 mice/sex/dose) at doses up to 325 mg/kg bw/day by gavage.
No genotoxicity was reported in both studies (EU, 2014; ECHA, 2018).
1. Suitable for use in all marine paints. Can effectively kill many bacteria and mildews like penicillium notatum, basidiomycetes, aspergillus niger, fusarium, and curvularia. Can be added at any production step for use; it is recommended to adopt the concentration of 5 ~ 15% (w/w).2. Operational instruction must be strictly followed. Avoid any contact with the skin. Wear protective clothes, goggles, and rubber gloves in operation. Once any contact with the skin happens, wash the skin immediately with plenty of water and soaps; when it splashes into eyes, wash immediately with plenty of water and buffer solutions.
[1] Patent: US2008/227986, 2008, A1. Location in patent: Page/Page column 3
