74-55-5

Myambutol,Lederle,US,1967

Antibacterial.

ChEBI: An ethylenediamine derivative that is ethane-1,2-diamine in which one hydrogen attached to each of the nitrogens is sutstituted by a 1-hydroxybutan-2-yl group (S,S-configuration). It is a bacteriostatic antimycobacterial d ug, effective against Mycobacterium tuberculosis and some other mycobacteria. It is used (as the dihydrochloride salt) in combination with other antituberculous drugs in the treatment of pulmonary and extrapulmonary tuberculosis; resistant str ins of M. tuberculosis are readily produced if ethambutol is used alone.

Ethambutol is a water-soluble, heat-stable compound that acts by inhibition of arabinosyl transferase enzymes that are involved in cell wall biosynthesis. Nearly all strains of M. tuberculosis and M. kansasii and most strains of Mycobacterium avium-intracellulare are sensitive to ethambutol. Drug resistance relates to point mutations in the gene (EmbB) that encodes the arabinosyl transferases that are involved in mycobacterial cell wall synthesis.

To 27 grams (2.55 mols) of 2-amino-1-butanol was added 100 grams (1.0 mol) of ethylene dichloride. The mixture was heated at reflux and in a few minutes, the exothermic reaction required the removal of exterior heating. After 10 minutes, exterior heating was recommenced for an additional 20 minutes. The hot mixture was then treated with 300 ml of methanol and then cautiously with 84 grams (2.1 mols) of sodium hydroxide in 80 ml of water.
The precipitated sodium chloride was removed by filtration. The excess 2- amino-1-butanol distilled as light yellow oil at 83° to 87°C/13 mm. The viscous residue distilled at 165° to 170°C/0.6 mm as a light yellow oil which tended to solidify in the air condenser; yield, 108 grams.
Recrystallization by dissolving in 80 ml of hot ethanol, adding about 150 ml of petroleum ether (BP 90° to 100°C) and cooling at 5°C overnight, gave 64 grams of white crystals melting at 128° to 132.5°C. This, on recrystallization from 100 ml of 95% ethanol, gave 35 grams of white crystals melting at 134.5° to 136°C and a second crop of 10 grams melting at 132.5° to 134°C which is the meso base. Its dihydrochloride melts at 202° to 203°C.
From the ethanolic filtrates upon addition of 130 ml of about 4 N ethanolic hydrochloric acid and cooling, there was obtained 55 grams of white crystals melting at 176.5° to 178°C and a second crop of 10 grams melting at 171.5° to 174.5°C. This is the dl racemate dihydrochloride.

Myambutol (Stat Trade);Aethambutolum;Embutol;Etbutol.

Antitubercular

Ethambutol is active against several species of mycobacteria and nocardiae. MICs on solid media are: M. tuberculosis 0.5–2 mg/L; M. kansasii 1–4 mg/L; other slowly growing mycobacteria 2–8 mg/L; rapidly growing pathogens 2–16 mg/L; Nocardia spp. 8–32 mg/L.
Resistance is uncommon and is a multistep process due to mutations in the embA, embB and embC gene cluster. A mutation in codon 306 of the embB gene predisposes to the development of resistance to a range of antituberculosis agents, possibly by affecting cell-wall permeability.

A synthetic ethylenediamine derivative formulated as the dihydrochloride for oral administration. The dry powder is very soluble and stable.

The mechanism of action of EMB remains unknown, although mounting evidence suggests a specific site of action for EMB. It has been known for some time that EMB affects mycobacterial cell wall synthesis; however, the complicated nature of the mycobacterial cell wall has made pinpointing the site of action difficult. In addition to the peptidoglycan portion of the cell wall, the mycobacterium have a unique outer envelop consisting of arabinofuranose and galactose (AG), which is covalently attached to the peptidoglycan and an intercalated framework of lipoarabinomannan (LAM) . The AG portion of the cell wall is highly branched and contains distinct segments of galactan and distinct segments of arabinan. At various locations within the arabinan segments (terminal and penultimate), the mycolic acids are attached to the C-5′ position of arabinan. Initially, Takayama et al. reported that EMB inhibited the synthesis of the AG portion of the cell wall. More recently, it has been reported that EMB inhibits the enzymes arabinosyl transferase. One action of arabinosyl transferase is to catalyze the polymerization of D-arabinofuranose, leading to AG. Ethambutol mimics arabinan, resulting in a buildup of the arabinan precursor β-D-arabinofuranosyl- 1-monophosphoryldecaprenol and, as a result, a block of the synthesis of both AG and LAM. The mechanism of resistance to EMB involves a gene overexpression o

Oral absorption: c. 80%, but some patients absorb it poorly
C_max 25 mg/kg oral: 2–6 mg/L after 2–3 h
Plasma half-life: 10–15 h
Volume of distribution: >3 L/kg
Plasma protein binding: 20–30%
Absorption is impeded by aluminum hydroxide and alcohol. It is concentrated in the phagolysosomes of alveolar macrophages. It does not enter the cerebrospinal fluid (CSF) in health but CSF levels of 25–40% of the plasma concentration, with considerable variation between patients, are achieved in cases of tuberculous meningitis.
Various metabolites are produced, including dialdehyde, dicarboxylic acid and glucuronide derivatives. Around 50% is excreted unchanged in the urine, with an additional 10–15% as metabolites, and 20% is excreted unchanged in feces.

Orally administered ethambutol is well absorbed (70–80%) from the gut, and peak serum concentrations are obtained within 2 to 4 hours of drug administration; it has a half-life of 3 to 4 hours. Ethambutol is widely distributed in all body fluids, including the cerebrospinal fluid, even in the absence of inflammation.A majority of the unchanged drug is excreted in the urine within 24 hours of ingestion. Up to 15% is excreted in the urine as an aldehyde and a dicarboxylic acid metabolite. Ethambutol doses may have to be modified in patients with renal failure.

Ethambutol has replaced aminosalicylic acid as a first-line antitubercular drug. It is commonly included as a fourth drug, along with isoniazid, pyrazinamide, and rifampin, in patients infected with MDR strains. It also is used in combination in the treatment of M. aviumintracellulare infection in AIDS patients.

Tuberculosis (initial intensive phase of short-course therapy)
Other mycobacterioses (M. kansasii, M. xenopi, M. malmoense and the M. avium complex) (with appropriate additional drugs)

The major toxicity associated with ethambutol use is retrobulbar neuritis impairing visual acuity and redgreen color discrimination; this side effect is dose related and reverses slowly once the drug is discontinued. Mild GI intolerance, allergic reaction, fever, dizziness, and mental confusion are also possible. Hyperuricemia is associated with ethambutol use due to a decreased renal excretion of urates; gouty arthritis may result.

The most important side effect is optic neuritis, which may be irreversible if treatment is not discontinued. This complication is rare if the higher dose (25 mg/kg) is given for no more than 2 months. National codes of practice for prevention of ocular toxicity should be adhered to; in particular, patients should be advised to stop therapy and seek medical advice if they notice any change in visual acuity, peripheral vision or color perception, and the drug should not be given to young children and others unable to comply with this advice.
Other side effects include gastrointestinal upsets, peripheral neuritis, arthralgia, nephritis, myocarditis, hyperuricemia, dermal hypersensitivity and, rarely, thrombocytopenia and hepatotoxicity.

Ethambutol, (±)-N,N-ethylenbis-(2-aminobutan-1-ol) (34.1.4), is synthesized in several different ways. According to one of them, nitropropane undergoes oxymethylation using formaldehyde, and the nitro group in the resulting 2-nitrobutanol (34.1.2) is reduced by hydrogen to an amino group, making racemic (±) 2-aminobutanol. L (￡?) tartaric acid is used to separate (￡?) 2-aminobutanol (34.1.3). Reacting this with 1, 2-dichloroethane in the presence of sodium hydroxide gives ethambutol (34.1.4).

An alternative method of synthesis consists of preparing (￡?) 2-aminobutanol (34.1.3) by reducing ethyl ester of L-2-aminobutyric acid hydrochloride with hydrogen using simultaneously Raney nickel and platinum oxide catalysts. This gives pure (￡?) 2-aminobutanol. Reacting this with 1,2-dichloroethane in the presence of sodium hydroxide gives the desired ethambutol (34.1.4).

The third way of synthesis is very interesting and resembles of the Ritter reaction, but which takes place in the presence of chlorine. This method consists of reacting 1-butene and acetonitrile in the presence of chlorine, which evidently results in the 1,4-addition of chlorine to the product of the Ritter reaction, forming an intermediate dichloride (33.1.5), which is hydrolyzed with water to make N-[1-(chloromethyl)-propyl]-acetamide (33.1.6). Heating this product with hydrochloric acid gives racemic (±) 2-aminobutanol, from which (￡?) 2-aminobutanol (34.1.3) is isolated as described above using L (￡?) tartaric acid. Reacting this with 1,2-dichloroethane in the presence of sodium hydroxide gives the desired ethambutol (34.1.4)

Store at -20°C